Installation

Read and follow all instructions and warnings in this manual before use to avoid risk of serious injury or death.

IMPORTANT SAFETY INFORMATION

 
WARNING

Read and follow all instructions and warnings before installation or use to avoid personal injury or death.

• Never stand, sit, or ride on Trolley.

• Never exceed 300 lbs maximum load limit in Trolley.

• Always use safety straps. Safety straps must be secured to Trolley prior to transport and to ensure Trolley does not roll out when tailgate is opened.

• Always ensure load in Trolley is uniformly distributed. When Trolley is extended past tailgate, load overhanging tailgate must not exceed 100 lbs.

• Trolley may roll unexpectedly if truck is not level. Load and unload Trolley only when truck is stationary and level.

• Never stand behind loaded Trolley until you are sure the Trolley will not move on its own.

• Always ensure tailgate is closed and Safety Straps secured before operating truck.

• When properly installed, Trolley should not overhang tailgate more than 18” when fully extended.

• Never install cord rail straps on tie-down anchors that are higher than the upright brackets on the Trolley. 

• Never install or use Trolley on trucks without tie-down anchors. 

• Before each use, tighten cord rail straps, cord rail clasps, and Trolley D-Loops, and inspect for wear or damage. Replace any damaged parts. 

• Never use Trolley as a ramp or outside truck bed. 

• Never use Trolley without tailgate.

• Always ensure payload is secure in Trolley.

installation instructions

WARNING! Truck must have tie-down anchors to install trolley.

WARNING! Before installation, ensure truck is on level surface, Engine OFF, and in Park with Emergency Brake applied.

Step 1

Feed long cord rail through driver-side tie down anchor nearest truck cab, and feed cut end of cord rail through loop end and pull tight. Repeat on the passenger side.

Step 2

Feed short cord rail through driver-side tie down nearest the tailgate, and feed clasp end of cord rail through loop end and pull tight.  Repeat on the passenger side.

WARNING! Do not secure to tie-down anchors higher than D-Loops on Trolley bracket.

Step 3

If you are in the truck bed at this point - Get Out. Place Trolley into truck bed and unfold.

WARNING! Never stand, sit, or ride on Trolley.

Step 4

Unfold both back brackets into upright and locked position (Push down to lock when upright).

WARNING! Keep hands and fingers clear of pinch points when folding/unfolding.

Step 5

Feed driver-side long cord rail through D-loop on back bracket of Trolley.  Repeat on passenger side.

Step 6

Feed driver-side long cord rail through clasp on short cord rail and pull to remove slack. Repeat on passenger side.

Step 7

Center Trolley between wheel wells and push Trolley into truck bed until end of the Trolley overhangs the truck bed by ¼ inch to ½ inch. You want the Trolley to be flush to the truck bed up to a ½ inch overhang.

Step 8

Pull both driver-side and passenger-side long cord rails further through the clasp on the short cord rail until tight and Trolley does not go in past the edge of the truck bed.

WARNING! Before each use, tighten cord rail straps, cord rail clasps, and Trolley D-Loops and inspect for wear or damage. Replace any damaged parts.

Step 9

Close tailgate to ensure that slight pressure is applied to the Trolley to prevent rolling in the truck bed when vehicle is in motion.

WARNING! Never use Trolley without a tailgate, or outside truck.

Step 10

Open tailgate and ensure the Trolley rolls out easily to the desired end point past your tailgate.  Apply pressure on the end of the Trolley when fully extended to ensure the Trolley does not tip.

Step 11

Extend Trolley as far as it will go past the tailgate after installation.  Measure distance from end of tailgate to end of Trolley.  Trolley should not extend past the tailgate more than 18”.  If it does, move the cord rails to a different D-loop on the Trolley back bracket.

Step 12

Install safety strap to tiedown near the tailgate on the passenger side and clip to Trolley. Repeat on driver side.

WARNING! Always use safety straps. Safety straps must be secured to Trolley prior to transport and to ensure Trolley does not roll out when tailgate is opened.