Installing the Truck Trolley
Step 1
Feed long cord rail through driver-side tie down anchor nearest truck cab, and feed cut end of cord rail through loop end and pull tight. Repeat on the passenger side.
Step 2
Feed short cord rail through driver-side tie down nearest the tailgate, and feed clasp end of cord rail through loop end and pull tight. Repeat on the passenger side.
WARNING! Do not secure to tie-down anchors higher than D-Loops on Trolley bracket.
Step 3
If you are in the truck bed at this point – Get Out. Place Trolley into truck bed and unfold.
WARNING! Never stand, sit, or ride on Trolley.
Step 4
Unfold both back brackets into upright and locked position (Push down to lock when upright).
WARNING! Keep hands and fingers clear of pinch points when folding/unfolding.
Step 5
Feed driver-side long cord rail through D-loop on back bracket of Trolley. Repeat on passenger side.
Step 6
Feed driver-side long cord rail through clasp on short cord rail and pull to remove slack. Repeat on passenger side.
Step 7
Center Trolley between wheel wells and push Trolley into truck bed until end of the Trolley overhangs the truck bed by ¼ inch to ½ inch. You want the Trolley to be flush to the truck bed up to a ½ inch overhang.
Step 8
Pull both driver-side and passenger-side long cord rails further through the clasp on the short cord rail until tight and Trolley does not go in past the edge of the truck bed.
WARNING! Before each use, tighten cord rail straps, cord rail clasps, and Trolley D-Loops and inspect for wear or damage. Replace any damaged parts.
Step 9
Close tailgate to ensure that slight pressure is applied to the Trolley to prevent rolling in the truck bed when vehicle is in motion.
WARNING! Never use Trolley without a tailgate, or outside truck.
Step 10
Open tailgate and ensure the Trolley rolls out easily to the desired end point past your tailgate. Apply pressure on the end of the Trolley when fully extended to ensure the Trolley does not tip.
Step 11
Extend Trolley as far as it will go past the tailgate after installation. Measure distance from end of tailgate to end of Trolley. Trolley should not extend past the tailgate more than 18”. If it does, move the cord rails to a different D-loop on the Trolley back bracket.
Step 12
Install safety strap to tiedown near the tailgate on the passenger side and clip to Trolley. Repeat on driver side.
